CARDINAL TECHNOLOGIES,INC.
2400BPS EXTERNAL MODEM (VER.1)
Card Type | Modem (synchronous/asynchronous) |
Chip Set | Unidentified |
Maximum Data Rate | 2400bps |
Data Bus | External |
Data Modulation Protocol | Bell 103/212A ITU-T V.21, V.22, V.22bis |
CONNECTIONS |
|||
Function |
Label |
Function |
Label |
Line in | CN1 |
DC power | CN4 |
Line out | CN2 |
Power switch | SW1 |
RS-232/422 | CN3 |
DIAGNOSTIC LED(S) |
|||
LED |
Color |
Status |
Condition |
HS |
Green |
On |
Modem is operating at faster than 2400bps |
HS |
Orange |
On |
Modem is operating at 2400bps |
HS |
Green |
Off |
Modem is operating at slower than 2400bps |
AA |
Green |
On |
Auto-answer enabled |
AA |
Green |
Off |
Auto-answer disabled |
AA |
Green |
Blinking |
Phone is ringing |
CD |
Green |
On |
Carrier signal detected |
CD |
Green |
Off |
Carrier signal not detected |
OH |
Green |
On |
Modem is off-hook |
OH |
Green |
Off |
Modem is on-hook |
RD |
Green |
On |
Modem is receiving data |
RD |
Green |
Off |
Modem is not receiving data |
SD |
Green |
On |
Modem is transmitting data |
SD |
Green |
Off |
Modem is not transmitting data |
TR |
Green |
On |
DTR signal is high |
TR |
Green |
Off |
DTR signal is low |
MR |
Green |
On |
Power is on |
MR |
Green |
Off |
Power is off |
MR |
Green |
Blinking |
Modem in test mode |
SUPPORTED COMMAND SET |
Basic AT Commands |
AT, +++, A/ |
A, B, D, E, H, L, M, O, Q, S, V, X, Y, Z |
&C, &D, &F, &G, &L, &P, &S, &T, &W, &Z |
S Registers |
S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12, S16, S18, S25, S26 |
Note: See MHI Help file for full command documentation. |
Proprietary AT Command Set
BIT MAPPED REGISTERS |
|
Register |
Default |
S14 |
Unidentified |
S20 |
16 |
S21 |
Unidentified |
S22 |
Unidentified |
S23 |
Unidentified |
S27 |
Unidentified |
REPORT INFORMATION |
|
Type: | Immediate |
Format: | AT [cmds] I n [cmds] |
Description: | Displays information requested |
Command |
Function |
I0 |
Reports modem code |
I1 |
Reports checksum |
I2 |
Verifies and reports checksum |