HEWLETT-PACKARD COMPANY
SURESTORE CD-WRITER PLUS 8200I, SURESTORE CD-WRITER PLUS 8210I
| Device Type | Internal CD-ROM |
| Interface | ATAPI |
| Spin Rate (Read/Write) | 24x/4x |
| Formats Supported Read | CD-XA, CD-DA, CD-I (photo,video), CD-ROM (Mode 1 & Mode 2), Photo-CD, Video-CD, CD-V, CD-E, CD+G, CD-R, CD-RW |
| Formats Supported Write | CD-XA, CD-DA, CD-I (photo,video), CD-ROM (Mode 1 & Mode 2), Photo-CD, Video-CD, CD-V, CD-E, CD+G, CD-R, CD-RW |
| View | Top |
CONNECTIONS |
|||
Function |
Label |
Function |
Label |
| Reserved | CN1 | Audio line out | CN2 |
ATAPI MASTER/SLAVE |
|||
Setting |
JP1/1 | JP1/2 | JP1/3 |
| Single drive only | Closed | Open | Open |
| Master in two drive system | Closed | Open | Open |
| Slave in two drive system | Open | Closed | Open |
| Master/slave determined by cable select | Open | Open | Closed |
DIAGNOSTIC LED(S) |
|||
LED |
Color |
Status |
Condition |
LED1 |
Red |
On | Unrecoverable drive error |
LED1 |
Green | Blinking | Writing |
LED1 |
Green | Blinking | Test writing |
LED1 |
Green | Blinking (rapid) | Drive diagnostics are being performed |
LED1 |
Green | Blinking | Drive firmware |
LED2 |
Green | Blinking | Disc is loading |
LED2 |
Green | On | Disc is loaded and ready |
LED2 |
Green | On | Disc is loaded and drive is in standby mode |
LED2 |
Red | Blinking | Disc is not readable |
LED2 |
Red | Blinking | Operation failed |
LED2 |
Red | On | Unrecoverable drive error |
LED2 |
Green | Blinking | Reading |
LED2 |
Green | On | Writing |
LED2 |
Red | On (2 seconds) | Load tray is locked and eject button has been pushed |
| LED2 | Green or Red | On (1 second) | Indicates pass or failure after each diagnostic test |
| LED2 | Green | Blinking | Drive firmware |
| LED2 | Green | On | Flash operation was successful |
| LED2 | Red | On | Flash operation failed |