Device Type	External Tape Drive
Interface	SCSI-2
Format	DLT
Sustained Transfer Rate	10.0 MBPS
View	Top

CONNECTIONS
Function	Label	Function	Label
Power connector	CN1	SCSI-2 connector	CN3
SCSI-2 connector	CN2	Power switch	SW2

FRONT PANEL

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Yellow	On	Tape density is 2.6GB
LED1	Yellow	Blinking	Tape density is not 2.6GB
LED2	Yellow	On	Tape density is 6.0GB
LED2	Yellow	Blinking	Tape density is not 6.0GB
LED3	Yellow	On	Tape density is 10.0/15.0GB
LED3	Yellow	Blinking	Tape density is not 10.0/15.0GB
LED4	Yellow	On	Tape density is 20.0GB
LED4	Yellow	Blinking	Tape density is not 20.0GB
LED5	Yellow	On	Tape density is 35.0GB
LED5	Yellow	Blinking	Tape density is not 35.0GB
LED6	Yellow	On	Compression mode is enabled
LED6	Yellow	Off	Compression mode is not enabled
LED7	Yellow	On	Tape density has been selected from front panel
LED7	Yellow	Blinking	Unit is in tape density selection mode
LED7	Yellow	Off	Tape density has been selected from host
LED8	Orange	On	Tape in drive is write-protected
LED8	Orange	Off	Tape in drive is not write-protected
LED9	Yellow	On	Tape loaded; unit is ready
LED9	Yellow	Blinking	Tape is being inserted or ejected
LED10	Yellow	On	Tape drive needs cleaning or tape is bad
LED10	Yellow	Off	Cleaning is complete or drive does not need cleaning
LED11	Green	On	Okay to use the cartridge handle
LED11	Green	Off	Do not use the cartridge handle

DLT7000 TAPE DRIVE

SCSI BUS PARITY
Setting	JP1
Disable SCSI parity checking	Pins 1 & 2 closed
Enable SCSI parity checking	Pins 1 & 2 open