COMPAQ COMPUTER CORPORATION
35/70-GB DLT (EXTERNAL)
| Device Type | External Tape Drive |
| Interface | SCSI-2 Fast Wide |
| Format | DLT |
| Sustained Transfer Rate | 5.00 MBPS |
| Size | 5.25 in. full height |
| View | Top |
CONNECTIONS |
|
Function |
Label |
| Power switch | SW2 |
DRIVE SELECT ID |
| Note: SW1 selects SCSI ID 0 - 15. |
| MANUFACTURERS RECOMMENDED MEDIA | ||
Tape |
Capacity Without Compression |
Capacity With Compression |
DLT tape III |
10GB |
20GB |
DLT tape IIIxt |
15GB |
30GB |
DLT tape IV |
35GB |
70GB |
CONNECTIONS |
|||
Function |
Label | Function | Label |
| Density selection button | PB1 |
Unload button | PB2 |
DIAGNOSTIC LEDS |
|||
LED |
Color |
Status |
Condition |
LED1 |
Yellow |
On |
Indicates tape is recorded in 2.6GB format |
LED1 |
Yellow |
Blinking |
Indicates tape is recorded in another density |
LED2 |
Yellow |
On |
Indicates tape is recorded in 6.0GB format |
LED2 |
Yellow |
Blinking |
Indicates tape is recorded in another density |
LED3 |
Yellow |
On |
Indicates tape is recorded in 10.0GB or 15.0GB format |
LED3 |
Yellow |
Blinking |
Indicates tape is recorded in another density |
LED4 |
Yellow |
On |
Indicates tape is recorded in 20.0GB format |
LED4 |
Yellow |
Blinking |
Indicates tape is recorded in another density |
LED5 |
Yellow |
On |
Indicates tape is recorded in 35.0GB format |
LED5 |
Yellow |
Blinking |
Indicates tape is recorded in another density |
LED6 |
Yellow |
On |
Compression mode enabled |
LED6 |
Yellow |
Off |
Compression mode disabled |
LED7 |
Yellow |
On |
Density from front panel selected |
LED7 |
Yellow |
Blinking |
Density selection mode established |
LED7 |
Yellow |
Off |
Density mode host selected |
LED8 |
Orange |
On |
Cartridge is write-protected |
LED8 |
Orange |
Off |
Cartridge is write-enabled |
LED9 |
Yellow |
Blinking |
Cartridge is loaded and tape is moving. |
LED9 |
Yellow |
Off |
Cartridge is loaded and ready for use. |
LED10 |
Yellow |
On |
Drive head requires cleaning |
LED10 |
Yellow |
Off |
No cleaning is required |
LED11 |
Green |
On |
Ability to operate cartridge insert/release handle |
LED11 |
Green |
Blinking |
No tape insertion while running POST |
LED11 |
Green |
Off |
Do not operate cartridge insert/release handle |
| Note: All four right side or all seven left side indicators ‘On’ designates that the Power-on self-test (POST) is starting. All four right side or all seven left side indicators ‘Blinking’ designates that an error has occurred in the POST; clear the error by pressing the unload button, or turn drive power off and then on again. If error remains, service is required. | |||