WINIC CORPORATION

W-MK17PCI

Card Type Hard drive controller card
Drives supported Four EIDE hard drives, CD-ROM drive
Floppy drives supported None
I/O Options Audio in - CD-ROM, earphone/speaker jack
Data Bus 32-bit PCI


CONNECTIONS

Function

Label

Function

Label

40-pin primary IDE(AT) connector CN1 Audio in - CD-ROM J1
40-pin secondary IDE(AT) connector CN2 Earphone/speaker connector J2
LED connector CN5    


USER CONFIGURABLE SETTINGS

Setting

Label

Position

» Interrupt request to PCI host disabled JP1 Open
  Interrupt request to PCI host enabled JP1 Closed
» IRQ14 select primary INT from hard drive (non-Intel motherboard) JP2 Pins 1 & 2 Closed
  IRQ14 select primary INT from chip (Intel motherboard) JP2 Pins 2 & 3 Closed
» IRQ15 select secondary INT from hard drive (non-Intel motherboard) JP3 Pins 1 & 2 Closed
  IRQ15 select secondary INT from chip (Intel motherboard) JP3 Pins 2 & 3 Closed
  ISA IRQ14, IRQ15 connect (IRQ to ISA BUS) JP6 Unidentified
  Reserve IRQ15 (not used) for normal motherboard JP7 Open
» Reserve IRQ15 (not used) for special motherboard (JP2 and JP3 must have pins 1 & 2 Closed) JP7 Closed
  Reserve IRQ14 (not used) for normal motherboard JP8 Open
» Reserve IRQ15 (not used) for special motherboard (JP2 and JP3 must have pins 1 & 2 Closed) JP8 Closed


DISK CHANGE/BASE ADDRESS/IDE SELECTION

Setting

JP9
» Disk chg. enabled Pins 1 & 2 Open
  Disk chg. disabled Pins 1 & 2 Closed
» Base address disabled Pins 3 & 4 Closed
  Base address enabled Pins 3 & 4 Open
» IDE enabled Pins 5 & 6 Open
  IDE disabled Pins 5 & 6 Closed


PRIMARY INTERRUPT SELECTION
 

Setting

JP4
»

INTA

Pins 7 & 8 Closed
 

INTB

Pins 5 & 6 Closed
 

INTC

Pins 3 & 4 Closed
 

INTD

Pins 1 & 2 Closed


SECONDARY INTERRUPT SELECTION
 

Setting

JP5
 

INTA

Pins 7 & 8 Closed
»

INTB

Pins 5 & 6 Closed
 

INTC

Pins 3 & 4 Closed
 

INTD

Pins 1 & 2 Closed